21.] Detail of machine specifications:
21.1.) Pay-off/Take-up stand 21.1.1.) Type: Floor type with drum traversing device. 21.1.2.) Stand material: made of ▓ square channel. 21.1.3.) Loading capacity: 8 Ton 21.1.4.) Drum Size: 1600mm/OD X 1080/W2
2600mm/OD X 1400/W2 21.2.) Loading/Unloading device:
21.2.1.) Lifting device: Up and down driven by 2 sets of 3HP X 1/30 reduction AC motors through a couple of screws in both side of vertical hanging arm, it can be operated individual or both in same time.
21.2.2.) Lifting speed: 360mm/min 21.2.3.) Lifting capacity: 8 Ton 21.3.) Drum clamping device 21.3.1.) Type: Screw lock up, both side support arm close & open to lock and release the drum.
11 / 14 Check out Http://www.pan-pioneer.com for our latest news TEL:+886-3-4604789 FAX:+886-3-4604788
PAN-PIONEER Co., Ltd.
民鋒股份有限公司
21.3.2.) Clamping speed: 10mm/sec for both side. 21.3.3.) Clamping force: can be adjusted by torque limiter for each side of support arm. 21.3.4.) Support arm moving width: 600mm 21.3.5.) Drum support end: 140mm with adaptors for small drums 21.3.6.) Driving motor: 1/60 reduction motor
21.4.) Traversing device: 21.4.1.) Type: Floor railway .type. The drum moving is done by motors with cable centering control system. 21.4.2.) Driving motor: AC servo motor with driver with speed synchronizing with
speed of drum. 21.4.3.) Traversing speed: 10mm/sec Max. 21.4.4.) Traverse width: 1600mm 21.4.5.) A auto/manual switch is available for traversing adjustment.
21.5.) Tension control device: 21.5.1.) Type: Driving motor tension control type. 21.5.2.) Tension force: Kg 21.5.3.) Tension adjust: Adjusted by loop detector on operation panel
21.6.) Touch roller device: 21.6.1.) Type: Two pieces of vertical traversing guide roller installed in front of the drum and on the center line for drum traversing pitch control. 21.6.2.) Guide roller: with 100mm diameter and 1000 height to keep the cable in the position of drum center line. 21.7.) Safety control device: 21.7.1.) Drum clamping position limit switch control with drum rotating motor circuit
interlock. 21.7.2.) Drum lifting up and down limit switches with auto stop circuit interlock. 21.7.3.) Traversing width limit switches detecting control. 21.7.4.) All rotating parts should be covered by safety cover.
21.8.) Operation panel: 21.8.1.) All the switches, push buttons and pilot lamps will be assembled together in a
compact operation panel. 21.8.2.) Type of operation panel: movable horizontal steel rope hanging type. 21.8.3.) Movable distance: whole width of pay-off/take-up stand of front side. 21.8.4.) All wiring inside the machine including DC motor are to be done by seller. 21.8.5.) Control items:
Power source control Current/voltage meter Drum loading/unloading Drum traversing Drum clamping Tension control Synchronization control