Multi-Wire Drawing Machine (for enameling machine)

　

1.] Main specification:

1.1.) Type: Multi In-Line Drawing Machine(5-Line x 8 dies)

1.2.) Application: For enamel wire production process as in-line process machine

1.3.) Inlet wire size range: mmφ

1.4.) Final wire size range: mmφ

1.5.) Speed of final capstan: m/min

1.6.) Inlet wire size (Supply wire size)

1.6.1.) 0.5 Final size ＜ 0.7 : Use 1.2mmφ wire supply

1.6.2.) 0.7 Final size 1.0 : Use 1.8mmφ wire supply

1.7.) Number of Lines: 5 lines/machine

1.8.) Number of drawing dies draft: 8 dies for each line

1.9.) Machine reduction

1.9.1.) First, Middle pass: %

1.9.2.) Final: %

1.10.) Power supply: 3 phase, 380V, 50Hz

1.11.) Capstan surface material

1.11.1.) First, Middle pass: Tungsten carbide coating

1.11.2.) Final pass: Ceramic coating (if possible)

1.12.) The number of machines: Total 4 sets

1.12.1.) Wiring direction from right hand to left hand: 2 sets

1.12.2.) Wiring direction from left hand to right hand: 2 sets

1.13.) Drawing dies: Use drawing die size as follows

Die's out of diameter × thickness:

Size mm: 25mm × 7mm

Size mm: 25mm × 10mm

Size mm: 25mm × 15mm

Sizemm up: 30mm ×15mm

1.14.) Driven motor:AC motor + AC vector type Inverter

1.15.) Other specifications:

All other detail machine specifications must be followed

2.] Composition of machine:

2.1.) In-Line drawing machine................................................1 set

2.2.) HP AC motor + Encode..............................................1 set

2.3.) AC Inverter (Japanese Brand or equivalent)..................1 set

2.4.) 1/25 Worm gear..............................................................1 set

2.5.) HP Ring blower ............................................................1 set

2.6.) Operation panel

2.7.) Control panel

2.8.) Electrical cable wiring in the machine

2.9.) Lubricant circulation piping in the machine